The DEV08 is a smaller, more compact DEV display. Offering a 8.4" LCD and a 3000:1 dimming ratio, the DEV08 can display mission-critical information under severe weather conditions (fog, sand, dust or smoke). The DEV08 is backwards compatible with legacy DEV cables and sensors.

Standard Features

• (1) Sensor Input (RS-170)
• (1) Composite AUX Video Input
• (1) Pass-through Video Sensor Output (RS-170)
• (1) RS422 Serial Data Interface
• VGA Resolution (640 x 480)
• MIL-C Connectors*
• LED Backlight (3000:1 Dimming Ratio)
• Anti-Reflective and Anti-Glare Treatments
• Enhanced Sunlight Readability
• 8.4" TFT AM LCD

Technical Specifications

Display	8.4” TFT AM LCD, VGA (640x480), 262,144 Colors
Nits	800 nits
Contrast Ratio	600:1
Dimming Ratio	3000:1
Viewing Angle	160° (H) x 140° (V)
Video Inputs	(1) RS-170
Connectors*	MIL-C Connectors (A1J1, A1J2, A1J4) BNC (A1J3, A1J6)
Housing	Milled AL, Black Hard Anodized
Mounting	Multiple mounting hole patterns on rear, top and bottom of display
Wide Range DC Power Input†	10-36 VDC (12,24,28 VDC nominal)
Power Conditioning	Protected against Internal Short Circuit, Load Dump, Over Voltage and Reverse Polarity
Power Consumption	15 Watts Maximum
Environmental Specifications
IP Rating	IP67 (NEMA 6 Submersible)
Operating Temperature	-40°C to 70°C (-40°F to 158°F)
Storage Temperature	-50°C to 80°C (-58°F to 176°F)
Humidity	0-100%
Altitude	45,000 ft.
Military Specifications
MIL-STD-461	EMI
MIL-STD-810	Method 501.4 II-Op; High Temperature
MIL-STD-810	Method 502.4 II-Op; Low Temperature
MIL-STD-810	Method 514.5; Procedure I, General Vibration
MIL-STD-810	Method 516.5; Procedure I, Functional Shock
MIL-STD-1275D†	Vehicle Power Requirements
MIL-A-8625 Type III (Class 1 & 2)	Standard Finish
MIL-PRF-22750F	Optional Painted Finish - Min. Qty Required
MIL-DTL-26482	Connector (Qualified)
MIL-DTL-38999	Connector (Qualified)

*Please note cables not included.

† The power range specified covers momentary environmental fluctuations generally found in a mobile environment while display is operating. For power initialization and continual operation, nominal voltages are required.

NOTE: CONTINUOUS PRODUCT DEVELOPMENT MAY NECESSITATE SPECIFICATION AND DESIGN CHANGES WITHOUT NOTICE