Remote Power Management Switch-48 VDC/(5) 12 Amp Outlets (Model:RPB+ DC30)

Applications:

• 48 VDC Power Control & Reboot
• Reboot Remote Routers, Telecom & Datacom Equipment
• Remote Reset of any -48 VDC Device

Features:

• Password Protected Access to Command Functions
• User Programmable Plug Names
• Status Display Shows System Information
• Simple Commands to Boot Each Plug or Switch ON/OFF
• Terminal Controlled via Modem or Terminal Server
• 115 VAC and 230 VAC Units Available
• High-Amperage -48 VDC Model Also Available

The RPB+ DC30 is the perfect solution for applications requiring remote reset capability of 48 VDC equipment. The RPB+ DC30 is an intelligent power reset unit, which provides password protection, user programmable plug "labels" to help identify your equipment and a user programmable location ID. The RPB+ DC30 can be controlled via modem or connected to a terminal server for either in- band or out-band control.

The RPB+ DC30 can be either code controlled, or controlled using your favorite terminal emulation software (ProComm®, Dynacomm®, HyperTerminal® etc.). Separate commands allow you to turn ON/OFF or reboot each of the five individual DC circuits, or reset all plugs. On command, the RPB+ DC30 will turn off one or all of the 5 circuits for a user-selectable delay period (5, 10, 15 or 30 seconds) then restores power to the plug. The RPB+ DC30 is ideal for rebooting your -48 VDC powered routers, servers, telecom equipment or any other -48 VDC equipment.

General Specifications:

Total Switched Power for all Plugs not to Exceed 30 Amps DC
Switched Outlets: Five (5) Circuits, Rated at 12 Amps Each.
Power Buss Input: 0 Volts, -48 VDC +/-10%
Interface: #6 2-Screw Terminal Block for Main Input and each of the Five (5) Switched Outputs.
Control Port: RS-232C DB-9 Male Connector (DTE)
Data Rate: 2400 or 9600 BPS, Switch Selectable
Size: 1.75"H x 19"W x 6.5"D (One Rack Unit)
19 Inch Rack Hardware Included.